Search results
Results from the WOW.Com Content Network
IHC Red Diamond 450D engine (cutaway view) The engine in these vehicles was an International Red Diamond 450D, a 451 cu in (7.4 L) overhead valve inline 6 cylinder gasoline engine developing 125 hp (93 kW) at 2700 rpm. The clutch was made by W.C. Lips, Model Z-32-S, and the transmission was an IHC Model F-54-D. This transmission had 5 forward ...
The W-series engine was made of cast iron. The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 ...
2.5 L; 152.5 cu in (2,499 cc) straight-four, with two (pushrod-actuated) valves-per-cylinder and indirect fuel injection. 92 mm × 94 mm (3.62 in × 3.70 in), the engine size is variably referred to as either 2,500 or 2,499 cc. This engine too has been called HR 492, signifying four cylinders of 92 mm (3.62 in) bore. Timing gears, not belt.
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
Turbo-Hydramatic 425 (TH425 or THM 425, [1] later 325) was an automatic transmission developed and produced by General Motors. The THM425 was a derivative of the THM400; most parts directly interchange and some others will interchange with minor modifications. The internal parts spin the opposite direction in the THM425; the helical angle of ...
The Unimog 425 is the first series production heavy duty Unimog series, made by Daimler-Benz from 1975 to 1988 in the Mercedes-Benz Gaggenau plant, alongside the long-wheelbase model Unimog 435. It was first presented to the public on the 1974 DLG show in Frankfurt, then named Unimog U 120 , indicating a power output of 120 PS (88.3 kW ; 118.4 ...
The early engines' bell pattern differed from AMC V8s. In 1971 AMC raised the block height and lengthened the stroke on the 199 and early 232 engines. The 199 became 232 cubic inches and the 232 became 258. These two RB or "raised block" engines shared the small bell pattern of the earlier engines for only the 1971 model year.