Search results
Results from the WOW.Com Content Network
A signal transmission may be simplex, half-duplex, or full-duplex. In simplex transmission, signals are transmitted in only one direction; one station is a transmitter and the other is the receiver. In the half-duplex operation, both stations may transmit, but only one at a time. In full-duplex operation, both stations may transmit simultaneously.
A duplex communication system is a point-to-point system composed of two or more connected parties or devices that can communicate with one another in both directions. Duplex systems are employed in many communications networks, either to allow for simultaneous communication in both directions between two connected parties or to provide a reverse path for the monitoring and remote adjustment ...
Electronic telegraphy, intended to be decoded by machine (radioteletype and digital modes) C: Facsimile (still images) D: Data transmission, telemetry or telecommand (remote control) E: Telephony (voice or music intended to be listened to by a human) F: Video (television signals) N: No transmitted information (other than existence of the signal) W
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
A data packet consists of the PID followed by 0–1,024 bytes of data payload (up to 1,024 bytes for high-speed devices, up to 64 bytes for full-speed devices, and at most eight bytes for low-speed devices), [12] and a 16-bit CRC. There are two basic forms of data packet, DATA0 and DATA1. A data packet must always be preceded by an address ...
Simplex is also used to describe a powering method where one or more signal conductors carries direct current to power a remote device, which sends its output signal back on the same conductor. Phantom powering as used in audio is a form of simplex powering, as the return current flows through the ground or shield conductor.
Asynchronous communication at the data link layer or higher protocol layers is known as statistical multiplexing, for example Asynchronous Transfer Mode (ATM). In this case, the asynchronously transferred blocks are called data packets, for example ATM cells.
After all bits have been shifted out and in, the master and slave have exchanged register values. If more data needs to be exchanged, the shift registers are reloaded and the process repeats. Transmission may continue for any number of clock cycles. When complete, the master stops toggling the clock signal, and typically deselects the slave.