enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ethernet over USB - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_USB

   One significant problem is the Ethernet frames are about 1500 bytes in size—about 3 USB 2.0 packets, and 23 USB 1.1 packets. The USB system works by each packet being sent as a transfer, a series of maximum-length packets terminated by a short packet or a special ZLP (zero-length packet). After this, there is bus latency, where nothing is ...

3. Attachment Unit Interface - Wikipedia

   en.wikipedia.org/wiki/Attachment_Unit_Interface

   The Attachment Unit Interface (AUI) is a physical and logical interface defined in the IEEE 802.3 standard for 10BASE5 Ethernet [1] and the earlier DIX standard. The physical interface consists of a 15-pin D-subminiature connector that links an Ethernet node's physical signaling to the Medium Attachment Unit (MAU), [2] sometimes referred to as ...

4. HDMI - Wikipedia

   en.wikipedia.org/wiki/HDMI

   HDMI 2.0, referred to by some manufacturers as HDMI UHD, was released on September 4, 2013. [112] HDMI 2.0 increases the maximum bandwidth to 18.0 Gbit/s. [112] [113] [114] HDMI 2.0 uses TMDS encoding for video transmission like previous versions, giving it a maximum video bandwidth of 14.4 Gbit/s. This enables HDMI 2.0 to carry 4K video at 60 ...

5. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   HDMI Ethernet Channel: HDMI 1.4 (2009) HDMI: HEC uses a hybrid to mix and separate 100BASE-TX's transmit and receive signals through a single twisted pair. Fiber-optical cable 100BASE‑FX: 802.3u-1995 (24, 26) ST, SC: 4B5B NRZI coded signaling, two strands of multi-mode optical fiber using 1300 nm wavelength. Maximum length is 400 meters for ...

6. Gender of connectors and fasteners - Wikipedia

   en.wikipedia.org/wiki/Gender_of_connectors_and...

   Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.

7. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   The X refers to the fact that transmit wires on an MDI device must be connected to receive wires on an MDI-X device. Straight-through cables connect pins 1 and 2 (transmit) on an MDI device to pins 1 and 2 (receive) on an MDI-X device. Similarly, pins 3 and 6 are receive pins on an MDI device and transmit pins on an MDI-X device.