Search results
Results from the WOW.Com Content Network
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met.
A limit switch with a roller-lever operator; this is installed on a gate on a canal lock, and indicates the position of a gate to a control system A limit switch mounted on a moving part of a bridge In electrical engineering , a limit switch is a switch operated by the motion of a machine part or the presence of an object.
A rotary hand control turns a shaft that is connected within the infinite switch to a cam and follower. At the off position both power line connections are interrupted. At all on positions the manual contacts connect one of the line terminals to the pilot lamp terminal and one of the terminals for the heating element being controlled.
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.
Typical usages include: Electrical ballast circuits to switch them off in the event of voltage falling below the operational value. [2]Switched-mode power supplies.When the system supply output impedance is higher than the input impedance of the regulator, an UVLO with a higher hysteresis should be used to prevent oscillations before settling down to a steady state and possible malfunctions of ...
A second switch brought a rheostat into circuit in series with the instrument and could be used to control the current through a device under test and the meter. The movement drew 12 mA for full-scale deflection and used a "universal shunt" permanently in parallel with the movement which increased the input terminal full-scale current to 16.6 ...