Search results
Results from the WOW.Com Content Network
An Integrated Solar Combined Cycle (ISCC) is a hybrid technology in which a solar thermal field is integrated within a combined cycle plant. In ISCC plants, solar energy is used as an auxiliary heat supply, supporting the steam cycle, which results in increased generation capacity or a reduction of fossil fuel use.
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...
Cogeneration or combined heat and power (CHP) is the use of a heat engine [1] or power station to generate electricity and useful heat at the same time. Cogeneration is a more efficient use of fuel or heat, because otherwise- wasted heat from electricity generation is put to some productive use.
Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [ 1 ] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).
The short circuit ratio (SCR) is an indicator of the strength of a network bus about the rated power of a device and is frequently used as a measure of system strength. A higher SCR value indicates a stronger system, meaning that the impact of disturbances on voltage and other variables will be minimized.
The combined cycle power plants consist of few stages with varying startup times with more than 8 hours required to get to full power from cold state: [5] the gas turbine can start in 15-30 minutes; the steam turbine (ST) heating process takes from 1 hour (for hot startup) to 6 hours (for cold startup);
Typically, a grid code will specify the required behavior of a connected generator during system disturbances. These include voltage regulation , power factor limits and reactive power supply, response to a system fault (e.g. short-circuit ), response to frequency changes on the grid, and requirement to " ride through " short interruptions of ...
In a normal combined cycle, so-called "waste heat" from the gas turbine exhaust is used in a Heat Recovery Steam Generator (HRSG) to make steam for the steam turbine cycle. An IGCC plant improves the overall process efficiency by adding the higher-temperature steam produced by the gasification process to the steam turbine cycle.