enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Tetens equation - Wikipedia

    en.wikipedia.org/wiki/Tetens_equation

    where temperature T is in degrees Celsius (°C) and saturation vapor pressure P is in kilopascals (kPa). According to Monteith and Unsworth, "Values of saturation vapour pressure from Tetens' formula are within 1 Pa of exact values up to 35 °C." Murray (1967) provides Tetens' equation for temperatures below 0 °C: [3]

  3. Goff–Gratch equation - Wikipedia

    en.wikipedia.org/wiki/Goff–Gratch_equation

    The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...

  4. Vapour pressure of water - Wikipedia

    en.wikipedia.org/wiki/Vapour_pressure_of_water

    The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.

  5. Vapor pressure - Wikipedia

    en.wikipedia.org/wiki/Vapor_pressure

    In the case of an equilibrium solid, such as a crystal, this can be defined as the pressure when the rate of sublimation of a solid matches the rate of deposition of its vapor phase. For most solids this pressure is very low, but some notable exceptions are naphthalene , dry ice (the vapor pressure of dry ice is 5.73 MPa (831 psi, 56.5 atm) at ...

  6. Water content - Wikipedia

    en.wikipedia.org/wiki/Water_content

    Water content or moisture content is the quantity of water contained in a material, such as soil (called soil moisture), rock, ceramics, crops, or wood. Water content is used in a wide range of scientific and technical areas, and is expressed as a ratio, which can range from 0 (completely dry) to the value of the materials' porosity at ...

  7. Saturation vapor density - Wikipedia

    en.wikipedia.org/wiki/Saturation_vapor_density

    The saturation vapor density (SVD) is the maximum density of water vapor in air at a given temperature. [1] The concept is related to saturation vapor pressure (SVP). It can be used to calculate exact quantity of water vapor in the air from a relative humidity (RH = % local air humidity measured / local total air humidity possible ) Given an RH percentage, the density of water in the air is ...

  8. Köhler theory - Wikipedia

    en.wikipedia.org/wiki/Köhler_theory

    The Köhler equation relates the saturation ratio over an aqueous solution droplet of fixed dry mass to its wet diameter as: [4] = ⁡ (), with: S {\displaystyle S} = saturation ratio over the droplet surface defined as S = p w / p w 0 {\textstyle S=p_{w}/p_{w}^{0}} , where p w {\textstyle p_{w}} is the water vapor pressure of the solution ...

  9. Richards equation - Wikipedia

    en.wikipedia.org/wiki/Richards_equation

    The Richards equation represents the movement of water in unsaturated soils, and is attributed to Lorenzo A. Richards who published the equation in 1931. [1] It is a quasilinear partial differential equation; its analytical solution is often limited to specific initial and boundary conditions. [2]