Ads
related to: stone masonry how to install a wall anchors for metal studs- Search By Category
Select a category to find pros.
Read reviews & hire with confidence
- How It Works
Tell us about your project. Compare
quotes & get the best pro for you.
- Get A Quick Estimate
Just enter your zip code to get
started & receive a fast free quote
- Visit Our Cost Guide
Learn more about the average cost
of different home projects.
- Search By Category
checkitsprice.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
Pry-out: a semi-conical fracture surface develops characterize the failure. The pryout mechanism for cast-in anchors usually occurs with very short, stocky studs. [19] The studs are typically so short and stiff that under a direct shear load, they bend causing contemporarily crushing in front of the stud and a crater of concrete behind.
The structural wall is put up first, and thin, flat stones are mortared onto the face of the wall. Metal tabs in the structural wall are mortared between the stones to tie everything together, to prevent the stonework from separating from the wall. Massive precut stone.
Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles, sheet piles, secant and tangent walls) to provide additional stability to cantilevered retaining walls. [1]
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
The thickness of typical thin stone veneer was three centimeters by the early 2000s. Anchors of support were provided by a specific type of stainless steel or "of aluminum with a non-corroding material separator between the metal and stone." These anchors are attached to the back of the panels with a rod. [2]: 28
A dutchman, or in some uses graving piece, is a matching piece of good material used to replace a relatively small damaged area that has been cut out of a larger item, to avoid having to replace the entire item; or, any of various techniques for accomplishing such a repair.
Ads
related to: stone masonry how to install a wall anchors for metal studscheckitsprice.com has been visited by 10K+ users in the past month