Search results
Results from the WOW.Com Content Network
A mass chromatogram is a representation of mass spectrometry data as a chromatogram, where the x-axis represents time and the y-axis represents signal intensity. [1] The source data contains mass information; however, it is not graphically represented in a mass chromatogram in favor of visualizing signal intensity versus time.
There are two steps when graphing the data which are to neglect all the points around zero on the y-axis to initially plot the line of best fit to find γ c ; however, when graphing the line initially if a point near 0 lands to the right of the intersection redo the regression including that point to make the measurement of the critical surface ...
On a planar graph, both axes represent the mole fractions of the lighter (lower boiling) component; the horizontal (x) and vertical (y) axes represents the liquid and vapor phase compositions, respectively. The x = y line (see Figure 1) represents the scenarios where the compositions of liquid and vapor are the same.
Each curve corresponds to a different Hill coefficient, labeled to the curve's right. The vertical axis displays the proportion of the total number of receptors that have been bound by a ligand. The horizontal axis is the concentration of the ligand. As the Hill coefficient is increased, the saturation curve becomes steeper.
The resulting signals and corresponding spiked silver concentrations are plotted, with concentration on the x-axis and the signal on the y-axis. A regression line is calculated through least squares analysis and the x-intercept of the line is determined by the ratio of the y-intercept and the slope of the regression line. This x-intercept ...
In chemical kinetics, an Arrhenius plot displays the logarithm of a reaction rate constant, ( (), ordinate axis) plotted against reciprocal of the temperature (/, abscissa). [1] Arrhenius plots are often used to analyze the effect of temperature on the rates of chemical reactions.
Plotted on the x-axis is the retention time and plotted on the y-axis a signal (for example obtained by a spectrophotometer, mass spectrometer or a variety of other detectors) corresponding to the response created by the analytes exiting the system. In the case of an optimal system the signal is proportional to the concentration of the specific ...
More technically, the abscissa of a point is the signed measure of its projection on the primary axis. Its absolute value is the distance between the projection and the origin of the axis, and its sign is given by the location on the projection relative to the origin (before: negative; after: positive). Similarly, the ordinate of a point is the ...