Search results
Results from the WOW.Com Content Network
diagram of a double-effect falling film evaporator. Condensing vapors from flash tank B1 heat evaporator A2. •1=feed •2=product •3=steam •4=vapors. In chemical engineering, a multiple-effect evaporator is an apparatus for efficiently using the heat from steam to evaporate water. [1]
A two evaporator single compressor with individual expansion valves for each evaporator after passing through the back pressure valve enters into the compressors and hence there is a significant rise in temperature is observed. This system helps in dropping the pressure from high pressure evaporators with the help of back pressure valves.
The energy consumption for single-effect evaporators is very high and is most of the cost for an evaporation system. Putting together evaporators saves heat and thus requires less energy. Adding one evaporator to the original decreases energy consumption by 50%. Adding another effect reduces it to 33% and so on.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
A two-cycle cascade refrigeration process schematic diagram. A cascade refrigeration cycle is a multi-stage thermodynamic cycle. An example two-stage process is shown at right. (Bottom on mobile) The cascade cycle is often employed for devices such as ULT freezers. [1]
The best way to achieve high economies (which can be well over 100%) is to use multiple effect evaporator, whereby the vapour from one evaporator – or effect – is used to heat the feed in the next effect, where boiling occurs at lower pressure and temperature [3] Thermo-compression of the vapour, whereby the vapour will condense at a ...
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible. A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator. As a refrigerant passes through a circuit containing these four elements, air ...
A vapor-compression evaporator, like most evaporators, can make reasonably clean water from any water source. In a salt crystallizer, for example, a typical analysis of the resulting condensate shows a typical content of residual salt not higher than 50 ppm or, in terms of electrical conductance , not higher than 10 μS/cm .