Search results
Results from the WOW.Com Content Network
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
Example of a system context diagram. [1] A system context diagram in engineering is a diagram that defines the boundary between the system, or part of a system, and its environment, showing the entities that interact with it. [2] This diagram is a high level view of a system. It is similar to a block diagram.
Helicopter rotors are designed to operate at a specific rotational speed. The throttle controls the power of the engine, which is connected to the rotor by a transmission. The throttle setting must maintain enough engine power to keep the rotor speed within the limits where the rotor produces enough lift for flight.
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Early cars had a hand lever to control the throttle, either directly, or by controlling an engine speed governor which in turn controlled both the throttle and timing. [6] In 1900 the Wilson-Pilcher car was introduced in Britain which had a hand controlled speed governor, and a foot throttle which could override the action of the governor.
The N 2 chart or N 2 diagram (pronounced "en-two" or "en-squared") is a chart or diagram in the shape of a matrix, representing functional or physical interfaces between system elements. It is used to systematically identify, define, tabulate, design, and analyze functional and physical interfaces.
The throttle is not the only control that can limit the locomotive's power output: during steady-state running of most locomotives, the throttle is usually set wide open and the power output is controlled by moving the reversing lever (2) closer to its mid-point ("reducing the cut-off") to limit the amount of steam admitted to the cylinders.