Ads
related to: replace plaster ceiling with drywall
Search results
Results from the WOW.Com Content Network
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
Lath and plaster largely fell out of favour in the U.K. after the introduction of plasterboard in the 1930s. [2] In Canada and the United States, wood lath and plaster remained in use until the process was replaced by transitional methods followed by drywall (the North American term for plasterboard) in the mid-twentieth century. [citation needed]
There is also a patented interlocking tin panel that will screw directly into existing drywall/popcorn/plaster ceilings, without the need for extensive plywood installation. Tin panels today are made in 24-by-24-inch (610 mm × 610 mm) and 24-by-48-inch (610 mm × 1,220 mm) sizes for easier handling and one-person installation.
A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.
The wattle and plaster process has been replaced in modern architecture by brick and mortar or by lath and plaster, a common building material for wall and ceiling surfaces, in which a series of nailed wooden strips are covered with plaster smoothed into a flat surface.
Gypsum waste primarily consists of waste from gypsum boards, which are wall or ceiling panels made of a gypsum core between paper lining. Such boards are also referred to as sheetrock, plasterboards, drywall, wallboards and gyprock. Gypsum waste in some countries also consists of gypsum blocks and plaster, among others.
Heat-resistant plaster is a building material used for coating walls and chimney breasts and for use as a fire barrier in ceilings. Its purpose is to replace conventional gypsum plasters in cases where the temperature can get too high for gypsum plaster to stay on the wall or ceiling.
A ceiling can also be the upper limit of a tunnel. The most common type of ceiling is the dropped ceiling, [citation needed] which is suspended from structural elements above. Panels of drywall are fastened either directly to the ceiling joists or to a few layers of moisture-proof plywood which are then attached to the joists. Pipework or ducts ...
Ads
related to: replace plaster ceiling with drywall