Search results
Results from the WOW.Com Content Network
The formula is based on experimental results by J. B. Johnson from around 1900 as an alternative to Euler's critical load formula under low slenderness ratio (the ratio of radius of gyration to effective length) conditions.
The analysis allows for a rational method of defining the material strength and results in a value less than, for example, 99.99% of the values from samples tested. By that method, in a sense, a separate factor of safety has been applied over and above the design factor of safety applied to a particular design that uses said material.
Shear stress in a horizontal bar loaded by two offset blocks. Another simple type of stress occurs when a uniformly thick layer of elastic material like glue or rubber is firmly attached to two stiff bodies that are pulled in opposite directions by forces parallel to the layer; or a section of a soft metal bar that is being cut by the jaws of a ...
For example, in the case of design for fire a load case of 1.0 x Dead Load + 0.8 x Live Load may be used, as it is reasonable to assume everyone has left the building if there is a fire. In multi-story buildings it is normal to reduce the total live load depending on the number of stories being supported, as the probability of maximum load ...
Buckling may occur even though the stresses that develop in the structure are well below those needed to cause failure in the material of which the structure is composed. . Further loading may cause significant and somewhat unpredictable deformations, possibly leading to complete loss of the member's load-carrying capac
Poisson's ratio of a material defines the ratio of transverse strain (x direction) to the axial strain (y direction)In materials science and solid mechanics, Poisson's ratio (symbol: ν ()) is a measure of the Poisson effect, the deformation (expansion or contraction) of a material in directions perpendicular to the specific direction of loading.
In the context to structural analysis, a structure refers to a body or system of connected parts used to support a load. Important examples related to Civil Engineering include buildings, bridges, and towers; and in other branches of engineering, ship and aircraft frames, tanks, pressure vessels, mechanical systems, and electrical supporting structures are important.
However, structures loaded in compression are subject to additional failure modes, such as buckling, that are dependent on the member's geometry. Tensile stress is the stress state caused by an applied load that tends to elongate the material along the axis of the applied load, in other words, the stress caused by pulling the material.