Ads
related to: swr meter for handheld sound system pricewalmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.
Checking the SWR is a standard procedure in a radio station. Although the same information could be obtained by measuring the load's impedance with an impedance analyzer (or "impedance bridge"), the SWR meter is simpler and more robust for this purpose. By measuring the magnitude of the impedance mismatch at the transmitter output it reveals ...
As an "all-band" transceiver, the TS-2000 offers a maximum power output of 100 watts on the HF, 6 meters, and 2 meters bands, 50 watts on 70 centimeters, and, with the TS-2000X or the optional UT-20, 10 watts on the 1.2 GHz or 23 centimeters band. The (American version) radio's main receiver covers 30 kHz through 60 MHz, 142 MHz through 152 MHz ...
NTi Audio AG is a manufacturer of test and measurement instruments for acoustics, audio and vibration applications. With headquarters in Schaan, Liechtenstein, the company specializes in end-of-line audio testing for manufacturing quality control purposes, [1] provides instruments for testing public address systems in safety-critical environments [2] and also produces handheld Audio Analyzers ...
Spectrum analysis can be used at audio frequencies to analyse the harmonics of an audio signal. A typical application is to measure the distortion of a nominally sinewave signal; a very-low-distortion sinewave is used as the input to equipment under test, and a spectrum analyser can examine the output, which will have added distortion products ...
In balanced audio systems, there are equal and opposite signals (difference-mode) in inputs, and any interference imposed on both leads will be subtracted, canceling out that interference (i.e., the common-mode). CMRR is a measure of a system's ability to ignore such interference and especially hum at its input.
Figure 1. Waveguide slotted line. Slotted lines are used for microwave measurements and consist of a movable probe inserted into a slot in a transmission line.They are used in conjunction with a microwave power source and usually, in keeping with their low-cost application, a low cost Schottky diode detector and VSWR meter rather than an expensive microwave power meter.
Ads
related to: swr meter for handheld sound system pricewalmart.com has been visited by 1M+ users in the past month