Search results
Results from the WOW.Com Content Network
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
With ISL, an Ethernet frame is encapsulated with a header that transports VLAN IDs between switches and routers. With IEEE 802.1Q the tag is internal. This is a key advantage for IEEE 802.1Q as it means tagged frames can be sent over standard Ethernet links. ISL does add overhead to the frame as a 26-byte header containing a 10-bit VLAN ID.
Static configuration of VLAN membership information via management mechanisms, which allow configuration of static VLAN registration entries. Combined static and dynamic configuration, in which some VLANs are configured via management mechanisms and for other VLANs, MVRP is relied on to establish the configuration.
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
Multiple VLAN Registration Protocol is an application of Multiple Registration Protocol that allows automatic configuration of VLAN information on network switches. Specifically, it provides a method to dynamically share VLAN information and configure the needed VLANs.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
On Cisco Devices, VTP (VLAN Trunking Protocol) maintains VLAN configuration consistency across a single Layer 2 network. VTP uses Layer 2 frames to manage the addition, deletion, and renaming of VLANs from switches in the VTP client mode. VTP is responsible for synchronizing VLAN information within a VTP domain and reduces the need to configure ...
The QoS technique developed by the working group, also known as class of service (CoS), is a 3-bit field called the Priority Code Point (PCP) within an Ethernet frame header when using VLAN tagged frames as defined by IEEE 802.1Q. It specifies a priority value of between 0 and 7 inclusive that can be used by QoS disciplines to differentiate ...