Search results
Results from the WOW.Com Content Network
In Linux distributions based on 2.2.x Linux kernels, the ifconfig and route commands are operated together to connect a computer to a network, and to define routes between computer networks. Distributions based on later kernels have deprecated ifconfig and route, replacing them with iproute2. Route for Linux was originally written by Fred N ...
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
It is commonly used in routing to depict the default route as a destination subnet. It matches all addresses in the IPv4 address space and is present on most hosts, directed towards a local router. It matches all addresses in the IPv4 address space and is present on most hosts, directed towards a local router.
When multiple route table entries match, the entry with the longest subnet mask is chosen as it is the most specific one. [2] If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use.
Entire IPv4 Internet, default route. In common usage, the first address in a subnet, all binary zero in the host identifier, is reserved for referring to the network itself, while the last address, all binary one in the host identifier, is used as a broadcast address for the network; this reduces the number of addresses available for hosts by 2.
Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...