Search results
Results from the WOW.Com Content Network
In any vacuum system, some gas will continue to escape into the chamber over time and slowly increase the pressure if it is not pumped out. [5] This leak rate is usually measured in mbar L/s or torr L/s. While some gas release is inevitable, if the leak rate is too high, it can slow down or even prevent the system from reaching low pressure.
Pressure-driven flow is a method to displace liquids in a capillary or microfluidic channel with pressure. The pressure is typically generated pneumatically by compressed air or other gases ( nitrogen , carbon dioxide , etc) or by electrical and magnetical fields or gravitation .
The rate does not depend on the downstream pressure at all. All other terms are constants that depend only on the composition of the material in the flow. Although the gas velocity reaches a maximum and becomes choked, the mass flow rate is not choked. The mass flow rate can still be increased if the upstream pressure is increased as this ...
Diagram of a vacuum flask Gustav Robert Paalen, Double Walled Vessel. Patent 27 June 1908, published 13 July 1909. The vacuum flask was designed and invented by Scottish scientist James Dewar in 1892 as a result of his research in the field of cryogenics and is sometimes called a Dewar flask in his honour.
The V-model is a graphical representation of a systems development lifecycle.It is used to produce rigorous development lifecycle models and project management models. The V-model falls into three broad categories, the German V-Modell, a general testing model, and the US government standard.
The pressure value that is attempted to compute, is such that when plugged into momentum equations a divergence-free velocity field results. The mass imbalance is often also used for control of the outer loop. The name of this class of methods stems from the fact that the correction of the velocity field is computed through the pressure-field.
In fluid dynamics, the entrance length is the distance a flow travels after entering a pipe before the flow becomes fully developed. [1] Entrance length refers to the length of the entry region, the area following the pipe entrance where effects originating from the interior wall of the pipe propagate into the flow as an expanding boundary layer.
A relief valve DN25 on cooling water pipe from heat exchanger Schematic diagram of a conventional spring-loaded pressure relief valve. A relief valve or pressure relief valve (PRV) is a type of safety valve used to control or limit the pressure in a system; excessive pressure might otherwise build up and create a process upset, instrument or equipment failure, explosion, or fire.