Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of engine oil into the intake manifold, which can be burned in the same fashion as Diesel fuel, thus causing runaway.
However, tests of the Camry by Car and Driver in 2009, attempting to use the brakes to stop acceleration of a purposely stuck throttle at 70, 100 and 120 miles per hour (110, 160 and 190 km/h), found that the test driver was able to reduce speed to 10 mph (16 km/h) in all instances, and in the 70 and 100 mph (110 and 160 km/h) tests, stop the ...
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
Fasten driver or passenger seat-belt (usu. with a buzzer) – Appears when the engine is switched and the driver's and/or passenger's seat belt is not buckled. A pressure sensor in the passenger seat prevents the passenger warning light from activating if the seat is unoccupied. Usually shaped like a person wearing a seat belt. [7]