Search results
Results from the WOW.Com Content Network
There is the ability to opt out of APM control on a device-by-device basis, which can be used if a driver wants to communicate directly with a hardware device. Communication occurs both ways; power management events are sent from the BIOS to the APM driver, and the APM driver sends information and requests to the BIOS via function calls.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
In computing, a devicetree (also written device tree) is a data structure describing the hardware components of a particular computer so that the operating system's kernel can use and manage those components, including the CPU or CPUs, the memory, the buses and the integrated peripherals.
On Windows Vista and Windows 7, this can be fixed by configuring the msahci device driver to start at boot time (rather than on-demand). Setting non-AHCI mode (i.e. IDE or Combined mode) in the BIOS will allow the user to boot into Windows, and thereby the required registry change can be performed.
Active-state power management (ASPM) is a power management mechanism for PCI Express devices to garner power savings while otherwise in a fully active state. Predominantly, this is achieved through active-state link power management; i.e., the PCI Express serial link is powered down when there is no traffic across it.
The device driver.. Device drivers are programs which allow software or higher-level computer programs to interact with a hardware device. These software components act as a link between the devices and the operating systems, communicating with each of these systems and executing commands.
This can happen when AC power is removed after entering ACPI S4. Applying AC power back and resuming from S4 may result in non detected or even non functioning USB device (erratum 12) Bogus USB ports will be detected by mobile PCH equipped with 6 USB ports (HM55) on the first EHCI controller.
Under real mode operating systems, such as DOS, calling INT 13h would jump into the computer's ROM-BIOS code for low-level disk services, which would carry out physical sector-based disk read or write operations for the program. In DOS, it serves as the low-level interface for the built-in block device drivers for hard disks and floppy disks.