enow.com Web Search

  1. Ad

    related to: 10 inch alnico guitar speaker parts catalog model

Search results

  1. Results from the WOW.Com Content Network
  2. Fender Harvard - Wikipedia

    en.wikipedia.org/wiki/Fender_Harvard

    The "Tweed" 5F10 model, [2] launched in 1955, but not in time for the Fender catalog of that year, [3] was a 10-watt amplifier utilising a 6AV6 (from 1956 a 6AT6) preamplifier tube, 12AX7 phase inverter tube, [note 1] a pair of 6V6GT power amplifier tubes, and one 5Y3GT rectifier tube, [4] with a Jensen P10R 10-inch speaker. The amplifier had a ...

  3. Jensen Loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Jensen_Loudspeakers

    The former Jensen Radio Manufacturing Company was founded in 1927 by Peter Laurits Jensen, the co-inventor of the first loudspeaker, in Chicago, Illinois.The company gained popularity in its early years, rising to its peak in the mid 1940s when Jensen speakers were selected to be used in the first production of a guitar amplifier by Fender Musical Instruments Corporation.

  4. JBL - Wikipedia

    en.wikipedia.org/wiki/JBL

    The D175 remained in the JBL catalog through the 1970s. Both of these were near-copies of Altec Lansing products. The first original product was the D130, a 15-inch transducer for which a variant remained in production for the next 55 years. The D130 featured a 4-inch (100 mm) flat ribbon wire voice coil and Alnico V magnet. Two other products ...

  5. Guitar speaker - Wikipedia

    en.wikipedia.org/wiki/Guitar_speaker

    The smallest guitar cabinets have one 6.5" or 8" speaker; these are usually practice amplifier units designed for private practice. Some cabinets designed for rehearsals and small- to mid-size venues contain two 10" or 12" speakers. Another popular format is four 10" or four 12" speakers. Some performers use two 4x10" or 4x12" cabinets. The ...

  6. Electrodynamic speaker driver - Wikipedia

    en.wikipedia.org/wiki/Electrodynamic_speaker_driver

    Alnico was commonly used until the 1960s, despite the problem of alnico magnets being partially demagnetized. [3] In the 1960s, most driver manufacturers switched from alnico to ferrite magnets, which are made from a mix of ceramic clay and fine particles of barium or strontium ferrite. Although the energy per kilogram of these ceramic magnets ...

  7. AHED (company) - Wikipedia

    en.wikipedia.org/wiki/Ahed_(company)

    The following is a fairly complete list of model numbers found on GBX power amps, combos and drivers: GBX 2153BS Powered Speaker (2 x 15 inch speakers for bass) GBX 4103BS Powered Speaker (4 X 10 inch speakers for bass) GBX 4103GS Powered Speaker (4 X 10 inch speakers for guitar) GBX 4123GS Powered Speaker (4 X 12 inch speakers for guitar)

  8. Altec Lansing Duplex - Wikipedia

    en.wikipedia.org/wiki/Altec_Lansing_Duplex

    The permanent magnet upgrade of the 601 was released in 1944 as the 604, at which point the 601 was discontinued. [5] The 604 was the same basic design using a 15-inch LF driver, but with a larger 3" voice coil, individual Alnico V magnets for the LF and HF drivers, and a cast aluminum frame.

  9. Guitar amplifier - Wikipedia

    en.wikipedia.org/wiki/Guitar_amplifier

    There is a wide range of sizes and power ratings for guitar amplifiers, from small, lightweight practice amplifiers with a single 6-inch speaker and a 10-watt amp to heavy combo amps with four 10-inch or four 12-inch speakers and a 100-watt amplifier, which are loud enough to use in a nightclub or bar performance.

  1. Ad

    related to: 10 inch alnico guitar speaker parts catalog model