enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   This is known as a right-handed (RH) thread, because it follows the right-hand grip rule. Threads oriented in the opposite direction are known as left-handed (LH). By common convention, right-handedness is the default handedness for screw threads. Therefore, most threaded parts and fasteners have right-handed threads.

3. Trapezoidal thread form - Wikipedia

   en.wikipedia.org/wiki/Trapezoidal_thread_form

   The actual thread heights on both the internal (nut) and external (bolt) threads differ from ⁠ P / 2 ⁠ by allowances (or clearances): A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches.

4. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The Unified Thread Standard (UTS) defines a standard thread form and series—along with allowances, tolerances, and designations—for screw threads commonly used in the United States and Canada. It is the main standard for bolts, nuts, and a wide variety of other threaded fasteners used in these countries.

5. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

6. Coupling nut - Wikipedia

   en.wikipedia.org/wiki/Coupling_nut

   Along with bolts or studs, coupling nuts are also often used to make homemade bearing and seal pullers/presses. The advantage of a connecting nut over a standard nut in this application is that, due to its length, a greater number of threads are engaged with the bolt. [6] This helps to spread the force over a larger number of threads, which ...

7. ISO 898 - Wikipedia

   en.wikipedia.org/wiki/ISO_898

   It specifically applies to fasteners that have an ISO metric screw thread as defined in ISO 68-1. The properties are defined for M1.6-39 with coarse threads and M8-39 with fine threads. The diameter and pitch combinations must adhere to ISO 261 and ISO 262 and the thread tolerances must adhere to ISO 965 parts 1, 2, and 4. [2]