Ads
related to: best 5 port gigabit switch gs116 hub setup for beginners windows 10
Search results
Results from the WOW.Com Content Network
4-port 10BASE-T Ethernet hub with selectable MDI-X/MDI port 8-port Ethernet hub with one 10BASE2 connector and eight 10BASE-T ports. An Ethernet hub, active hub, network hub, repeater hub, multiport repeater, or simply hub [a] is a network hardware device for connecting multiple Ethernet devices together and making them act as a single network segment.
A switch that also operates at these higher layers is known as a multilayer switch. Segmentation involves the use of a switch to split a larger collision domain into smaller ones in order to reduce collision probability and to improve overall network throughput. In the extreme case (i.e. micro-segmentation), each device is directly connected to ...
NAT Port Mapping Protocol (NAT-PMP) is a protocol introduced by Apple as an alternative to IGDP. Port Control Protocol (PCP) is a successor of NAT-PMP. UPnP Internet Gateway Device Protocol (UPnP IGD) is supported by many small NAT gateways in home or small office settings. It allows a device on a network to ask the router to open a port.
Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...
Router with two dozen 10 Gigabit Ethernet ports and three types of physical-layer module. 10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers) or two switches to each other.
Autonegotiation can be used by devices that are capable of more than one transmission rate, different duplex modes (half duplex and full duplex), and different transmission standards at the same speed (though in practice only one standard at each speed is widely supported).
Since common Category 5 cable has four pairs, it is possible to use the spare pairs (pins 4–5, 7–8) in 10- and 100-Mbit/s configurations for other purposes. The spare pairs may be used for power over Ethernet (PoE), for two plain old telephone service (POTS) lines, or for a second 10BASE-T or 100BASE-TX connection.
Ads
related to: best 5 port gigabit switch gs116 hub setup for beginners windows 10