Search results
Results from the WOW.Com Content Network
A graph of the A-, B-, C- and D-weightings across the frequency range 10 Hz – 20 kHz Video illustrating A-weighting by analyzing a sine sweep (contains audio). A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. [1]
Dynamic range is a measure of how small you can measure a signal relative to the maximum input signal the device can measure. Expressed in decibels, the dynamic range is 20 log (Vmax/Vmin). For example, a device with an input range of ±10 V and a dynamic range of 110 dB will be able to measure a signal as small as 10 μV.
The commonly used reference sound exposure in air is [2] E 0 = 400 μ P a 2 ⋅ s . {\displaystyle E_{0}=400~\mathrm {\mu Pa^{2}\cdot s} .} The proper notations for sound exposure level using this reference are L W /(400 μPa 2 ⋅s) or L W (re 400 μPa 2 ⋅s) , but the notations dB SEL , dB(SEL) , dBSEL, or dB SEL are very common, even if ...
Sound has three basic components, the wavelength, frequency, and speed. In sound measurement, we measure the loudness of the sound in decibels (dB). Decibels are logarithmic with 0 dB as the reference. [1] There are also a range of frequencies that sounds can have. Frequency is the number of times a sine wave repeats itself in a second. [2]
A sound level meter (also called sound pressure level meter (SPL)) is used for acoustic measurements. It is commonly a hand-held instrument with a microphone. The best type of microphone for sound level meters is the condenser microphone, which combines precision with stability and reliability. [1]
B-weighted sound pressure level is written either as dB B or L B, and C-weighted sound pressure level is written either as dB C or L C. Unweighted sound pressure level is called "linear sound pressure level" and is often written as dB L or just L. Some sound measuring instruments use the letter "Z" as an indication of linear SPL. [13]
The weighting curve is specified by both a circuit diagram of a weighting network and a table of amplitude responses. Above is the ITU-R 468 Weighting Filter Circuit Diagram. The source and sink impedances are both 600 ohms (resistive), as shown in the diagram. The values are taken directly from the ITU-R 468 specification.
Audiogram. An audiogram is a graph that shows the audible threshold for standardized frequencies as measured by an audiometer.The Y axis represents intensity measured in decibels (dB) and the X axis represents frequency measured in hertz (Hz). [1]