Search results
Results from the WOW.Com Content Network
Conversely, when pH = pK a, the concentration of HA is equal to the concentration of A −. The buffer region extends over the approximate range pK a ± 2. Buffering is weak outside the range pK a ± 1. At pH ≤ pK a − 2 the substance is said to be fully protonated and at pH ≥ pK a + 2 it is fully dissociated (deprotonated).
The pH range is commonly given as zero to 14, but a pH value can be less than 0 for very concentrated strong acids or greater than 14 for very concentrated strong bases. [2] The pH scale is traceable to a set of standard solutions whose pH is established by international agreement. [3]
When the acidic medium in question is a dilute aqueous solution, the is approximately equal to the pH value, which is a negative logarithm of the concentration of aqueous + in solution. The pH of a simple solution of an acid in water is determined by both K a {\displaystyle K_{{\ce {a}}}} and the acid concentration.
From the titration of protonatable group, one can read the so-called pK a 1 ⁄ 2 which is equal to the pH value where the group is half-protonated (i.e. when 50% such groups would be protonated). The pK a 1 ⁄ 2 is equal to the Henderson–Hasselbalch pK a (pK HH a) if the titration curve follows the Henderson–Hasselbalch equation. [14]
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
The Henderson–Hasselbalch equation can be used to model these equilibria. It is important to maintain this pH of 7.4 to ensure enzymes are able to work optimally. [10] Life threatening Acidosis (a low blood pH resulting in nausea, headaches, and even coma, and convulsions) is due to a lack of functioning of enzymes at a low pH. [10]
The isoelectric point (pI, pH(I), IEP), is the pH at which a molecule carries no net electrical charge or is electrically neutral in the statistical mean. The standard nomenclature to represent the isoelectric point is pH(I). [1] However, pI is also used. [2] For brevity, this article uses pI.
With pOH obtained from the pOH formula given above, the pH of the base can then be calculated from =, where pK w = 14.00. A weak base persists in chemical equilibrium in much the same way as a weak acid does, with a base dissociation constant (K b) indicating the strength of the base. For example, when ammonia is put in water, the following ...