enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. F connector - Wikipedia

   en.wikipedia.org/wiki/F_connector

   The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable. The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold ...

3. RG-6 - Wikipedia

   en.wikipedia.org/wiki/RG-6

   The number was assigned sequentially. The RG unit indicator is no longer part of the JETDS system (MIL-STD-196E) and cable sold today under the RG-6 label is unlikely to meet military specifications. In practice, the term RG-6 is generally used to refer to coaxial cables with an 18 AWG (1.024 mm) center conductor and 75 ohm characteristic ...

4. Electrical termination - Wikipedia

   en.wikipedia.org/wiki/Electrical_termination

   A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.

5. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...

6. CoaXPress - Wikipedia

   en.wikipedia.org/wiki/CoaXPress

   The maximum transmission distance is depending on the bit rate and the quality of the cable. RG-11, RG-6, RG-59, and other cable types can be used. It is also possible to reuse existing coaxial cable when upgrading from an analogue to a digital camera system. The original connector for CoaXPress is a 75 Ω IEC 61169-8 BNC connector.

7. Fiber cable termination - Wikipedia

   en.wikipedia.org/wiki/Fiber_cable_termination

   The most common types that are added to fiber optic cable in inside plant environments are LC, SC, ST, and FC. Some fiber connectors are pre-polished mechanical connectors for ease of installation or anaerobic connectors which require cleaving and polishing. [1] Once the appropriate connector has been identified, the termination process can begin.