Search results
Results from the WOW.Com Content Network
The frequency response for a conventional LP player might be 20 Hz to 20 kHz, ±3 dB. The low-frequency response of vinyl records is restricted by rumble noise (described above), as well as the physical and electrical characteristics of the entire pickup arm and transducer assembly. The high-frequency response of vinyl depends on the cartridge.
AC bias is the addition of an inaudible high-frequency signal (generally from 40 to 150 kHz) to the audio signal. Most contemporary tape recorders use AC bias. When recording, magnetic tape has a nonlinear response as determined by its coercivity. Without bias, this response results in poor performance, especially at low signal levels.
Pulse waves, usually 50%, 25%, and 12.5%, make up the soundtracks of classic video games. The term PWM as used in sound (music) synthesis refers to the ratio between the high and low level being secondarily modulated with a low-frequency oscillator. This gives a sound effect similar to chorus or slightly detuned oscillators played together.
The higher frequency sound waves have a shorter wavelength and thus don't spread out as rapidly. For this reason, the resulting directivity of these devices is far higher than physically possible with any loudspeaker system. However, they are reported to have limited low-frequency reproduction abilities. See sound from ultrasound for more ...
HF's position in the electromagnetic spectrum.. High frequency (HF) is the ITU designation [1] for the band of radio waves with frequency between 3 and 30 megahertz (MHz). It is also known as the decameter band or decameter wave as its wavelengths range from one to ten decameters (ten to one hundred meters).
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
Musical sound can be more complicated than human vocal sound, occupying a wider band of frequency. Music signals are time-varying signals; while the classic Fourier transform is not sufficient to analyze them, time–frequency analysis is an efficient tool for such use. Time–frequency analysis is extended from the classic Fourier approach.
High fidelity (often shortened to Hi-Fi or HiFi) is the high-quality reproduction of sound. [1] It is popular with audiophiles and home audio enthusiasts. Ideally, high-fidelity equipment has inaudible noise and distortion , and a flat (neutral, uncolored) frequency response within the human hearing range .