Ad
related to: vw throttle body problems 2010 chevy tahoe
Search results
Results from the WOW.Com Content Network
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
The LSSV is a GM-built Chevrolet Silverado 2500 HD, Chevrolet Tahoe, or Chevrolet Suburban that is powered by the 5.3 L V8 for the Tahoe, 6.0 L V8 for the Suburban, and a Duramax 6.6 L V8 turbo diesel engine for the pickup trucks. As GM has periodically redesigned its civilian trucks and SUVs since 2001, LSSVs have also been updated cosmetically.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
The closed throttle provides engine braking by forcing the engine to generate a vacuum between the throttle and the cylinders. Typically, the controls for a compression brake consist of an on/off switch and often a selector that controls the number of cylinders on which the brake is active. Throttle and clutch switches are integral with the system.
It is usually installed right behind the throttle valve in the throttle body. Single-point injection was a relatively low-cost way for automakers to reduce exhaust emissions to comply with tightening regulations while providing better "driveability" (easy starting, smooth running, freedom from hesitation) than could be obtained with a carburetor.
Ad
related to: vw throttle body problems 2010 chevy tahoe