Ads
related to: amp for dt 880 600 ohm- 2-Channel Amps
Power a Single Set of Speakers or
Switch to Mono Mode to Drive a Sub
- Multi-Room Amps
For Those Looking to Power Speakers
Across Multiple Zones of a Home
- 5-Channel Amps
Power Front and Rear Speakers Plus
a Channel to Drive Your Subwoofer
- All Amplifiers
Shop a Wide Selection of Home and
Car Amplifiers to Fit Your Needs
- 2-Channel Amps
ebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Line outputs usually present a source impedance of from 100 to 600 ohms. The voltage can reach 2 volts peak-to-peak with levels referenced to −10 dBV (300 mV) at 10 kΩ . The frequency response of most modern equipment is advertised as at least 20 Hz to 20 kHz, which corresponds to the range of human hearing .
First introduced in 1948, it sported the name "Champion 800" [2] (with 8" speaker), changing a year later to "Champion 600" (6" speaker) with circuit designation 5B1. It was rated at about 3 watts, featuring a "T.V. Front" style cabinet; the 800 was covered in greenish fabric while the 600 featured two-tone blonde and brown vinyl covering.
The Hot Rod Deluxe is an all tube combo amp rated at 40 watts. It utilizes a single 12-inch Celestion A-Type Speaker. It utilizes a single 12-inch Celestion A-Type Speaker. The Hot Rod Deluxe is a mono-channel amplifier featuring 3 switchable gain levels: "Clean", "Drive", and "More Drive" selectable on either the control panel or footswitch ...
The Hot Rod DeVille is a modified version of the earlier Fender Blues DeVille from the Blues amplifier line and has a higher level of gain in its preamplification signal. The DeVille incorporates a 60 watt amplifier and has been offered in two different models: a 212, with 2, 12-inch speakers and a 410, with 4, 10-inch speakers. The 410 ...
Typical push–pull audio tube power amplifier, matched to loudspeaker with an impedance-matching transformer. Audio amplifiers typically do not match impedances, but provide an output impedance that is lower than the load impedance (such as < 0.1 ohm in typical semiconductor amplifiers), for improved speaker damping.
The Ampeg SVT is a bass guitar amplifier designed by Bill Hughes and Roger Cox for Ampeg and introduced in 1969. The SVT is a stand-alone amplifier or "head" as opposed to a "combo" unit comprising amp and speaker(s) in one cabinet, and was capable of 300 watts output at a time when most amplifiers could not exceed 100 watts output, making the SVT an important amp for bands playing music ...
Ads
related to: amp for dt 880 600 ohmebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month