Search results
Results from the WOW.Com Content Network
As of 2018, the U.S. Army Research Laboratory (ARL) led research and development activity for CARC and was the approving authority of CARC products for the Department of Defense (DoD). [3] [4] Since 1985, U.S. Army Regulation 750-1 mandated the use of CARC systems on all tactical equipment. Regulations mandated the hardening of equipment (i.e ...
The type of acrylic used in tanning beds is most often formulated from a special type of polymethyl methacrylate, a compound that allows the passage of ultraviolet rays. Sheets of PMMA are commonly used in the sign industry to make flat cut out letters in thicknesses typically varying from 3 to 25 millimeters (0.1 to 1.0 in).
Acrylic elastomer is a general term for a type of synthetic rubber whose primary component is acrylic acid alkyl ester (ethyl or butyl ester). [3] Acrylic elastomer possesses characteristics of heat and oil resistance, with the ability to withstand temperatures of 170–180 °C. It is used primarily for producing oil seals and packaging related ...
A United States data item description (DID) is a completed document defining the data deliverables required of a United States Department of Defense contractor. [1] A DID specifically defines the data content, format, and intended use of the data with a primary objective of achieving standardization objectives by the U.S. Department of Defense .
Acrylic resin is a common ingredient in latex paint (UK: "emulsion paint"). Latex paints with a greater proportion of acrylic resin offer better stain protection, greater water resistance, better adhesion, greater resistance to cracking and blistering, and resistance to alkali cleaners compared to those with vinyl. [2]
Butyl acrylate is of low acute toxicity with an LD 50 (rat) of 3143 mg/kg. [4]In rodent models, butyl acrylate is metabolized by carboxylesterase or reactions with glutathione; this detoxification produces acrylic acid, butanol, and mercapturic acid waste, which are excreted.
Polyacrylonitrile (PAN) was first synthesized in 1930 by Hans Fikentscher and Claus Heuck in the Ludwigshafen works of the German chemical conglomerate IG Farben. [3] However, as PAN is non-fusible, and did not dissolve in any of the industrial solvents being used at the time, further research into the material was halted. [4]
ASA can be made by either a reaction process of all three monomers (styrene, acrylonitrile, acrylic ester) or a graft process, although the graft process is the typical method. A grafted acrylic ester elastomer is introduced during the copolymerization of styrene and acrylonitrile. The elastomer is introduced as a powder. [11]