enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. End-of-train device - Wikipedia

   en.wikipedia.org/wiki/End-of-train_device

   A "dumb" ETD can be as simple as a red flag attached to the coupler on the last car of the train, whereas "smart" devices monitor functions such as brake line pressure and accidental separation of the train using a motion sensor, functions that were previously monitored by a crew in the caboose. [1]

3. Brake wear indicator - Wikipedia

   en.wikipedia.org/wiki/Brake_wear_indicator

   The embedded sensor in the brake pad 2 contacts the rotor and creates a connection to ground of the sensor. The metal plate 3 contacts the rotor and creates a noise. This wear clip should be positioned so that the rotor contacts the clip before it contacts the brake pad. The rotor should push against that clip, not drag it away from the brake pad.

4. Residual-current device - Wikipedia

   en.wikipedia.org/wiki/Residual-current_device

   A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage circuit breaker, that interrupts an electrical circuit when the current passing through line and neutral conductors of a circuit is not equal (the term residual relating to the imbalance), therefore ...

5. Brake lining - Wikipedia

   en.wikipedia.org/wiki/Brake_lining

   The brake lining may also become contaminated by oil or leaked brake fluid. Typical symptoms will be brake chatter, where the pads vibrate as the lining grabs and releases the rotor's surface. The solution is to repair and clean the source of the contamination, replace the damaged pads and possibly also have the rotors re-skimmed or replaced if ...

6. List of automobiles known for negative reception - Wikipedia

   en.wikipedia.org/wiki/List_of_automobiles_known...

   [20] In the August 1990 issue of Road & Track, it was noted of the Biturbo's reliability, "Mis-set carburetor float levels caused the engine to stumble during left turns, pick-up wires in the distributor cracked from the heat, water ran through cylinder sleeves, fluids leaked from faulty seals throughout the drivetrain, fuse boxes melted, and ...

7. Brake-by-wire - Wikipedia

   en.wikipedia.org/wiki/Brake-by-wire

   SpeedE, an academic concept car developed for studying drive-by-wire technologies such as brake-by-wire. Brake-by-wire technology in the automotive industry is the ability to control brakes through electronic means, without a mechanical connection that transfers force to the physical braking system from a driver input apparatus such as a pedal or lever.