Search results
Results from the WOW.Com Content Network
LM336 2.5 V or 5 V Zener reference diode with temperature coefficient trimmer [53] LM368 Yes 2.5 V precision voltage reference [54] LM169 LM369 LM199 Yes 2.5 V temperature compensated precision voltage reference [55] LM185 LM285 LM385 Fixed (1.2 V, 2.5 V) or adjustable micropower voltage reference [56] [57] LM129 LM329 LM129
This is an accepted version of this page This is the latest accepted revision, reviewed on 2 December 2024. Restoring the software of an electronic device to its original state For the Tilian Pearson album, see Factory Reset (album). A factory reset, also known as hard reset or master reset, is a software restore of an electronic device to its original system state by erasing all data ...
On an IBM mainframe, a power-on reset (POR) is a sequence of actions that the processor performs either due to a POR request from the operator or as part of turning on power. The operator requests a POR for configuration changes that cannot be recognized by a simple System Reset .
Resettable fuses - PolySwitch devices. A resettable fuse or polymeric positive temperature coefficient device (PPTC) is a passive electronic component used to protect against overcurrent faults in electronic circuits.
Touchmaster Five with carriage return lever at left. Originally, the term "carriage return" referred to a mechanism or lever on a typewriter.For machines where the type element was fixed and the paper held in a moving carriage, this lever was on the left attached to the moving carriage, and operated after typing a line of text to cause the carriage to return to the far right so the type ...
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
Button, coin, or watch cells. A button cell, watch battery, or coin battery is a small battery made of a single electrochemical cell and shaped as a squat cylinder typically 5 to 25 mm (0.197 to 0.984 in) in diameter and 1 to 6 mm (0.039 to 0.236 in) high – resembling a button.
Low-dropout (LDO) regulators operate similarly to all linear voltage regulators.The main difference between LDO and non-LDO regulators is their schematic topology.Instead of an emitter follower topology, low-dropout regulators consist of an open collector or open drain topology, where the transistor may be easily driven into saturation with the voltages available to the regulator.