Search results
Results from the WOW.Com Content Network
In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1] It is typically used in combination with components such as switches and transistors , which physically interrupt the connection of subsequent components to ground or to V CC .
The E series of preferred numbers was chosen such that when a component is manufactured it will end up in a range of roughly equally spaced values (geometric progression) on a logarithmic scale. Each E series subdivides each decade magnitude into steps of 3, 6, 12, 24, 48, 96, and 192 values, termed E3 , E6 , and so forth to E192 , with maximum ...
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
Variable resistors can be used to adjust circuit elements (such as a volume control or a lamp dimmer), or as sensing devices for heat, light, humidity, force, or chemical activity. Resistors are common elements of electrical networks and electronic circuits and are ubiquitous in electronic equipment. Practical resistors as discrete components ...
Pull-up resistors are provided by the I3C controller. External pull-up resistors are no longer needed. Clock Stretching – devices are expected to be fast enough to operate at bus speed. The I3C controller is the sole clock source. I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address.
There is nothing special about pull-up or pull-down resistors, it's just how the resistors are connected in a circuit. The voltage drop across any resistor depends on the current flowing; in a circuit, currents can change and consequently the voltages at specific points in that circuit may go up at one end of what is called a pull-up resistor ...
From Wikipedia, the free encyclopedia. Redirect page
The moving ranges involved are serially correlated so runs or cycles can show up on the moving average chart that do not indicate real problems in the underlying process. [ 2 ] : 237 In some cases, it may be advisable to use the median of the moving range rather than its average, as when the calculated range data contains a few large values ...