Search results
Results from the WOW.Com Content Network
In a single read or write operation, only one bank is accessed, therefore the number of bits in a column or a row, per bank and per chip, equals the memory bus width in bits (single channel). The size of a bank is further determined by the number of bits in a column and a row, per chip, multiplied by the number of chips in a bank.
4096 bytes = 4 KiB: A memory page in x86 (since Intel 80386) and many other architectures, also the modern Advanced Format hard disk drive sector size. 4 kB: About one page of text from a novel; 120 kB: The text of a typical pocket book; 1 MiB: A 1024×1024 pixel bitmap image with 256 colors (8 bpp color depth) 3 MB: A three-minute song (133 ...
Also some memory controllers have a maximum supported number of ranks. DRAM load on the command/address (CA) bus can be reduced by using registered memory. [citation needed] Predating the term rank (sometimes also called row) is the use of single-sided and double-sided modules, especially with SIMMs. While most often the number of sides used to ...
Memory organization is an aspect of computer architecture that is concerned with the storage and transfer of data and programs [1]. There are several ways to organise memories with respect to the way they are connected to the cache: one-word-wide memory organisation; wide memory organisation; interleaved memory organisation; independent memory ...
Single-level storage (SLS) or single-level memory is a computer storage term which has had two meanings. The two meanings are related in that in both, pages of memory may be in primary storage ( RAM ) or in secondary storage (disk), and that the physical location of a page is unimportant to a process.
CMOS memory was commercialized by RCA, which launched a 288-bit CMOS SRAM memory chip in 1968. [23] CMOS memory was initially slower than NMOS memory, which was more widely used by computers in the 1970s. [24] In 1978, Hitachi introduced the twin-well CMOS process, with its HM6147 (4 kb SRAM) memory chip, manufactured with a 3 μm process. The ...
In DOS memory management, conventional memory, also called base memory, is the first 640 kilobytes of the memory on IBM PC or compatible systems. It is the read-write memory directly addressable by the processor for use by the operating system and application programs.
A row data buffer may be from 32 to 4096 bytes long, depending on the type of memory. Rows larger than 32 bytes ignore some of the low-order address bits in the Activate command. Rows smaller than 4096 bytes ignore some of the high-order address bits in the Read command. Non-volatile memory does not support the Write command to row data buffers.