Ads
related to: category 7 trailer connector dimensions list
Search results
Results from the WOW.Com Content Network
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
7-pin blade connector (Towing vehicle side) This is common for RVs and other large trailers which have additional loads beyond the basic for tail lights and brake/turn signals. The standard is defined by SAE J2863, Automotive Trailer Tow Connector. #
A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."
The trailer tongue (North America) or coupling (outside North America) slips over a trailer hitch ball attached to a receiver hitch mount or integral with the hitch. A larger, heavy-duty gooseneck ball size: 3 in (76.2 mm) is typically used for towing greater than 10,000 pounds (4.5 t), and this towing capacity falls outside of the scope of SAE ...
Round 7-pin trailer connector Type 1, Australian Standard 2513. In this pinout for an ISO 1724 connector, the position light pin is used for electric brakes (Pin 5, 58R), which means that if you connect a trailer with electric brakes to a towing vehicle wired according to ISO 1724 and turn on the position lights the trailer will be braking.
Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
Ads
related to: category 7 trailer connector dimensions list