Search results
Results from the WOW.Com Content Network
Acceptance angle. The "acceptance angle" figure illustrates this concept. The concentrator is a lens with a receiver R. The left section of the figure shows a set of parallel rays incident on the concentrator at an angle α < θ to the optical axis. All rays end up on the receiver and, therefore, all light is captured.
Numerical aperture is commonly used in microscopy to describe the acceptance cone of an objective (and hence its light-gathering ability and resolution), and in fiber optics, in which it describes the range of angles within which light that is incident on the fiber will be transmitted along it.
The solid angle of a sphere measured from any point in its interior is 4 π sr. The solid angle subtended at the center of a cube by one of its faces is one-sixth of that, or 2 π /3 sr. The solid angle subtended at the corner of a cube (an octant) or spanned by a spherical octant is π /2 sr, one-eight of the solid angle of a sphere. [1]
Acceptance angle may refer to: Half of the angular aperture of an optical system; Acceptance angle (optical fiber), the angle in an optical fiber below which rays are ...
As a result, the fiber transmits all rays that enter the fiber with a sufficiently small angle to the fiber's axis. The limiting angle is called the acceptance angle, and the rays that are confined by the core/cladding boundary are called guided rays. The core is characterized by its diameter or cross-sectional area. In most cases the core's ...
For step index fiber, light entering the fiber will be guided if it makes an angle with the fiber axis that is less than the fiber's acceptance angle. A leaky ray or tunneling ray is a ray in an optical fiber that geometric optics predicts would totally reflect at the boundary between the core and the cladding , but which suffers loss due to ...
The limit on maximum concentration (shown) is an optic with an entrance aperture S, in air (n i = 1) collecting light within a solid angle of angle 2α (its acceptance angle) and sending it to a smaller area receiver Σ immersed in a medium of refractive index n, whose points are illuminated within a solid angle of angle 2β. From the above ...
Due to these sources of error, seasonally adjusted parabolic troughs are generally designed with a lower concentration acceptance product. Parabolic trough concentrators have a simple geometry, but their concentration is about 1/3 of the theoretical maximum for the same acceptance angle , that is, for the same overall tolerances of the system ...