enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cutoff voltage - Wikipedia

   en.wikipedia.org/wiki/Cutoff_voltage

   The cut-off voltage is different from one battery to the other and it is highly dependent on the type of battery and the kind of service in which the battery is used. When testing the capacity of a NiMH or NiCd battery a cut-off voltage of 1.0 V per cell is normally used, whereas 0.9 V is normally used as the cut-off voltage of an alkaline cell ...

3. Cut-off (electronics) - Wikipedia

   en.wikipedia.org/wiki/Cut-off_(electronics)

   Triodes: triodes cut off when applied grid bias is too low. This will be a negative voltage under ordinary conditions. Tetrode, pentode etc.: There is some degree of interaction between the grids, and values will vary from one device to another. Anode voltage also affects cutoff voltage. Prolonged periods in cut-off leads to cathode poisoning.

4. Passive sign convention - Wikipedia

   en.wikipedia.org/wiki/Passive_sign_convention

   Illustration of the "reference directions" of the current (), voltage (), and power () variables used in the passive sign convention.If positive current is defined as flowing into the device terminal which is defined to be positive voltage, then positive power (big arrow) given by the equation = represents electric power flowing into the device, and negative power represents power flowing out.

5. Automotive battery - Wikipedia

   en.wikipedia.org/wiki/Automotive_battery

   A typical 12 V, 40 Ah lead-acid car battery. An automotive battery, or car battery, is a rechargeable battery that is used to start a motor vehicle.. Its main purpose is to provide an electric current to the electric-powered starting motor, which in turn starts the chemically-powered internal combustion engine that actually propels the vehicle.

6. Battery terminal - Wikipedia

   en.wikipedia.org/wiki/Battery_terminal

   positive on left and negative on the right corner; negative on the left and positive on the right corner. Terminals can also be both on the long or short side of the battery, or diagonally opposed, or in the middle. Purchasing the wrong configuration may prevent battery cables from reaching the battery terminals.

7. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   from 2nd battery and 12/24 V relay: 31 return to battery- or direct to ground 31a return to battery- 12/24 V relay 31b return to battery- or ground through switch 85d 31c return to battery- 12/24 V relay 31, 31a Electric motors; 32 return 31 33 main terminal (swap of 32 and 33 is possible) 30 33a limit 33b field 54e 33f 2. slow rpm: 33g 3. slow ...