Search results
Results from the WOW.Com Content Network
As an example, if a tire size has two sets of numbers (6-12, 5.00-15, 11.2-24), then the first number (5.00-15) is the approximate width in inches, and the second number (5.00-15) is the rim diameter in inches. If a tire size has three sets of numbers (15x6.00-6, 26x12.00-12, 31x15.50-15), then the first number (26x12.00-12) is the approximate ...
The inner width of the rim on which the tire is mounted should be about 65% of the tire's nominal section width for tires smaller than 30 mm and 55% for those larger. The section height of a tire is usually identical to its section width (for tires less than 28 mm, 2.5 mm have to be added to the width to get the height).
Modern road tires have several measurements associated with their size as specified by tire codes like 225/70R14. The first number in the code (e.g., "225") represents the nominal tire width in millimeters. This is followed by the aspect ratio (e.g.,"70"), which is the height of the sidewall expressed as a percentage of the nominal tire width.
Plus sizing is the practice of replacing an automotive wheel with one of a larger diameter fitted with a new tire of lower aspect ratio so that the new tire has close to the same diameter and circumference as the original tire to minimize any changes in speedometer accuracy, torque and traction control, while reducing sidewall flex and (generally) increasing cornering ability.
For example, a 10% change in load or inflation pressure usually does not result in a 10% change in the contact patch area [3] because the load or pressure on a tire can be altered freely, and the contact patch area is affected by the tire geometry and stiffness. Further, the size of the contact patch cannot be simply calculated as load divided ...
ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles. The great advantage of ETRTO sizing is that it is unambiguous; previously, nominal dimensions were used which were interpreted in different ways by different countries and manufacturers - a problem for the end user.
A = number of wheels (twin-mounted tires count as one wheel) B = number of driven wheels / = the fore of the rear axles is steered (pusher axle) * = the rearmost of the rear axles is steered (tag axle) C = number of steered wheels - = separates axle groups and/or different axle functions (6x4-2 is 6x6 with undriven rear axle)
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...