Search results
Results from the WOW.Com Content Network
Consumer voltage converters (also known as "travel converters") are used when traveling between countries that use ~120 V versus ~240 V AC mains power. (There are also consumer "adapters" which merely form an electrical connection between two differently shaped AC power plugs and sockets , but these change neither voltage nor frequency.)
The switch is typically a MOSFET, IGBT, or BJT transistor. The Ćuk converter [1] (Serbo-Croatian:, English: / ˈ tʃ uː k /) is a type of buck-boost converter with low ripple current. [2] A Ćuk converter can be seen as a combination of boost converter and buck converter, having one switching device and a mutual capacitor, to couple the energy.
The input is left side, the output with load is right side. The switch is typically a MOSFET, IGBT, or BJT transistor. A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply.
The output of the SEPIC is controlled by the duty cycle of the electronic switch (S1). A SEPIC is essentially a boost converter followed by an inverted buck-boost converter. While similar to a traditional buck-boost converter, it has a few advantages. It has a non-inverted output (the output has the same electrical polarity as the input).
Essentially, a chopper is an electronic switch that is used to interrupt one signal under the control of another. In power electronics applications, since the switching element is either fully on or fully off, its losses are low and the circuit can provide high efficiency. However, the current supplied to the load is discontinuous and may ...
A simple voltage dropper can be used to reduce the voltage for low-power devices; if more than 12V is required, or for high-powered devices, a switched-mode power supply is used. The output will usually be DC in the range 1.5–24 V. Power supplies that output either 100–120 V AC or 210–240 V AC are available; they are called inverters ...
An American Rotary Phase Converter with a Transformer. A phase converter is a device that converts electric power provided as single phase to multiple phase or vice versa. The majority of phase converters are used to produce three-phase electric power from a single-phase source, thus allowing the operation of three-phase equipment at a site that only has single-phase electrical service.
Low-power switch-mode power supplies (cell phone charger, standby power supply in PCs) Low-cost multiple-output power supplies (e.g., main PC supplies <250 W [ citation needed ] ) The flyback converter is commonly used at the 50 to 100 W power range, as well as in highvoltage power supplies for televisions and computer monitors - Fundamentals ...