Search results
Results from the WOW.Com Content Network
A WebDAV request may contain many sub-requests involving file operations, requiring a long time to complete the request. This code indicates that the server has received and is processing the request, but no response is available yet. [3] This prevents the client from timing out and assuming the request was lost. The status code is deprecated. [4]
A four-port "long cable" "external box" USB hub A four-port "compact design" USB hub: upstream and downstream ports shown. A USB hub is a device that expands a single Universal Serial Bus (USB) port into several so that there are more ports available to connect devices to a host system, similar to a power strip. All devices connected through a ...
HTTP Status Code 402, also known as "Payment Required," is a standard response code in the Hypertext Transfer Protocol (HTTP). It is part of the HTTP/1.1 protocol defined by the Internet Engineering Task Force (IETF) in the RFC 7231 [ 1 ] specification.
Rather than tie up the high-bandwidth USB bus sending data to a slower USB device, the nearest high-bandwidth capable hub receives a SPLIT token followed by one or two USB packets at high-bandwidth, performs the data transfer at full- or low-bandwidth, and provides the response at high-bandwidth when prompted by a second SPLIT token.
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
The USB 3.0 specification defined a new architecture and protocol named SuperSpeed (aka SuperSpeed USB, marketed as SS), which included a new lane for a new signal coding scheme (8b/10b symbols, 5 Gbit/s; later also known as Gen 1) providing full-duplex data transfers that physically required five additional wires and pins, while preserving the ...
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [6] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.
However, portable devices typically cannot provide enough power for hard-drive disk enclosures (a 2.5-inch (64 mm) hard drive typically requires the maximum 2.5 W in the USB specification) without a self-powered USB hub. A Windows Mobile device cannot display its file system as a mass-storage device unless the device implementer adds that ...