Search results
Results from the WOW.Com Content Network
This class of status code indicates the client must take additional action to complete the request. Many of these status codes are used in URL redirection. [2]A user agent may carry out the additional action with no user interaction only if the method used in the second request is GET or HEAD.
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification. It is primarily a means of testing the communications infrastructure. Loopback can take the form of communication channels with only one communication endpoint.
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer. Ethernet Configuration Testing Protocol was implemented on DEC hosts and Cisco routers. [2]
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM).This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs).
Broken network For example, in this illustration, node A is transmitting data to node C via node B. If the link between nodes B and C goes down and B has not yet informed node A about the breakage, node A transmits the data to node B assuming that the link A-B-C is operational and of lowest cost.
By far the most popular FCS algorithm is a cyclic redundancy check (CRC), used in Ethernet and other IEEE 802 protocols with 32 bits, in X.25 with 16 or 32 bits, in HDLC with 16 or 32 bits, in Frame Relay with 16 bits, [3] in Point-to-Point Protocol (PPP) with 16 or 32 bits, and in other data link layer protocols.
The address 127.0.0.1 is the standard address for IPv4 loopback traffic; the rest are not supported by all operating systems. However, they can be used to set up multiple server applications on the host, all listening on the same port number. In the IPv6 addressing architecture [3] there is only a single address assigned for loopback: ::1. The ...
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet. The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).