Search results
Results from the WOW.Com Content Network
Thus, a representation that compresses the storage size of a file from 10 MB to 2 MB yields a space saving of 1 - 2/10 = 0.8, often notated as a percentage, 80%. For signals of indefinite size, such as streaming audio and video, the compression ratio is defined in terms of uncompressed and compressed data rates instead of data sizes:
File size is a measure of how much data a computer file contains or how much storage space it is allocated. Typically, file size is expressed in units based on byte . A large value is often expressed with a metric prefix (as in megabyte and gigabyte ) or a binary prefix (as in mebibyte and gibibyte ).
This is a basic example of run-length encoding; there are many schemes to reduce file size by eliminating redundancy. The Lempel–Ziv (LZ) compression methods are among the most popular algorithms for lossless storage. [6] DEFLATE is a variation on LZ optimized for decompression speed and compression ratio, [7] but compression
G4 compression would actually increase the file size on this type of image. G4 typically achieves a 20:1 compression ratio. [ citation needed ] For an 8.5"×11" page scanned at 200 DPI , this equates to a reduction from 467.5 kB to 23.4 kB (95% compression ratio).
2 76 bits – Maximum volume and file size in the Unix File System (UFS) and maximum disk capacity using the 64-bit LBA SCSI standard introduced in 2000 using 512-byte blocks. [20] 10 23: 1.0 × 10 23 bits – increase in information capacity when 1 joule of energy is added to a heat-bath at 1 K (−272.15 °C) [21] 2 77
For communication throughput, a base unit of bit is common. For example, using the metric kilo prefix, a kilobyte is 1000 bytes and a kilobit is 1000 bits. Use of metric prefixes is common, but often inaccurate since binary storage hardware is organized with capacity that is a power of 2 – not 10 as the metric prefixes are.
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits, kilobits, or bits per second.
35 mm film is scanned for release on DVD at 1080 or 2000 lines as of 2005. The actual resolution of 35 mm original camera negatives is the subject of much debate. Measured resolutions of negative film have ranged from 25–200 LP/mm, which equates to a range of 325 lines for 2-perf, to (theoretically) over 2300 lines for 4-perf shot on T-Max 100.