Search results
Results from the WOW.Com Content Network
The reed valve blocks served as intermediate main bearings. Because the valves occupied space already necessary for the main bearings instead of mounting to an extension of the crankcase, crankcase volume was minimized, resulting in a higher crankcase compression ratio, and more power in proportion to displacement than the competition.
1.5 L (1,493 cc or 91.1 cu in) I3, with a single overhead camshaft, four valves-per-cylinder, and common-rail direct fuel injection. This engine was designed in 1998 with the related 4-cylinder variant R 420 SOHC.
RS-25 gimbal test. Each engine is installed with a gimbal bearing, a universal ball and socket joint which is bolted to the launch vehicle by its upper flange and to the engine by its lower flange. It represents the thrust interface between the engine and the launch vehicle, supporting 7,480 lb (3,390 kg) of engine weight and withstanding over ...
It was used by Mercury Marine, named the Mercruiser 7.4 MPI and later Mercruiser 7.4 Mag. Mercury also adopted the 8.1L engine L29 applications: 1996–2000 Chevrolet C/K / GMC Sierra 2500, 3500, and C3500HD (above 8,500 pounds GVWR) 1996–1999 Chevrolet/GMC Suburban 2500; 1996–2000 Chevrolet Express/GMC Savana 3500; Mercury Marine Inboard
Grease fitting on a bearing A grease nipple on the driver's door of a 1956 VW Beetle. A grease fitting, grease nipple, Zerk fitting, grease zerk, Alemite fitting, or divit is a metal fitting used in mechanical systems to feed lubricants, usually lubricating grease, into a bearing under moderate to high pressure using a grease gun.
Such bearings should be equipped with the shaft position control system, which adjusts the fluid pressure and consumption according to the rotation speed and shaft load. [4] In fluid-dynamic bearings, the bearing rotation sucks the fluid on to the inner surface of the bearing, forming a lubricating wedge under or around the shaft.
The oil droplets then pass through drillings to the bearings and thereby lubricate the moving parts. [3] Provided that the bearing is a ball bearing or a roller bearing , splash lubrication would usually be sufficient; however, plain bearings typically need a pressure feed to maintain the oil film, loss of which leads to overheating and seizure.
For instance, .001 of an inch worn off of the engine's main bearings can cause up to a 20% loss in oil pressure. [6] Simply replacing worn bearings may fix this problem, but in older engines with a lot of wear not much can be done besides completely overhauling the engine. Particles in the oil can also cause serious problems with oil pressure.