Search results
Results from the WOW.Com Content Network
In countries where the sockets are polarised, polarity testing is a simple test that can be carried out using a polarity tester to determine whether the line and neutral of the plug end are correctly connected to the corresponding terminals at the socket end. [11] [12]
A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...
Live testing. Earth fault loop impedance testing: this test is to check that if a fault did occur, that the system meets requirements to cause a disconnection of the supply within the time limit specified by standards Insulation resistance testing Polarity test: a test to check that the connections are connected in the right sequence
When testing power supply circuits, a high-impedance connection (that is, a nearly open-circuit fault such as a burned switch contact or wire joint) in the power path might still allow enough voltage/current through to register on a high-impedance digital voltmeter, but it probably can't actuate the solenoid voltmeter. For use with high ...
Auto-polarity for direct-current readings, shows if the electric polarity of applied voltage is positive (agrees with meter lead labels) or negative (opposite polarity to meter leads). Sample and hold, which will latch the most recent reading for examination after the instrument is removed from the circuit under test.
Pole mounted distribution transformers are manufactured with additive polarity, while instrument transformers are made with subtractive polarity. Where markings have been obscured or are suspect, a test can be made by interconnecting the windings and exciting the transformer, and measuring the voltages. [4]
In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker ) across the chosen path.
A calibration first consists of a preliminary test in which the fundamental calibration capability is checked. The quartz control plates must meet the required minimum requirements with respect to their dimensions, optical pureness, flatness, parallelism of the faces and optical axis errors.