Search results
Results from the WOW.Com Content Network
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...
This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
High-strength steel bolts usually have a hexagonal head with an ISO strength rating (called property class) stamped on the head. And the absence of marking/number indicates a lower grade bolt with low strength. The property classes most often used are 5.8, 8.8, and 10.9. The number before the point is the ultimate tensile strength in MPa ...
Hanger bolt - Bolt that has no head, machine threaded body followed by a wood threaded screw tip. Allow nuts to be attached to what is really a screw. Hex bolt - Bolt with a hexagonal head and threaded shank. Section immediately under head may be unthreaded for fastening thicker materials. J bolt - Bolt shaped like the letter J, used for tie downs.
Metric thread stud bolts: Active: DIN 976-2: Metric interference-fit thread stud bolts: Active: DIN 977: Hexagon weld nuts with flange: Withdrawn: DIN EN ISO 21670: ISO 21670: DIN 979: Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread – Product grades A and B: Active: DIN 980: All-metal prevailing torque type ...
The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances ...