Ads
related to: attaching stair stringers to wall
Search results
Results from the WOW.Com Content Network
In two-story construction, openings are left in the floor system for a stairwell, in which stair risers and treads are most often attached to squared faces cut into sloping stair stringers. [citation needed] Interior wall coverings in light-frame construction typically include wallboard, lath and plaster or decorative wood paneling. [citation ...
Stairs are not suitable for wheelchairs and other vehicles. A stairlift is a mechanical device for lifting wheelchairs up and down stairs. For sufficiently wide stairs, a rail is mounted to the treads of the stairs, or attached to the wall. A chair is attached to the rail and the person on the chair is lifted as the chair moves along the rail.
This page was last edited on 1 May 2021, at 05:46 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply ...
A strongback is a beam or girder which acts as a secondary support member to an existing structure. A strongback in a staircase is usually ordinary two-by dimensional lumber attached to the staircase stringers to stiffen the assembly.
A dog-leg staircase A quarter-landing, on a dog-leg staircase, is made into an architectural feature, by the use of arches, vaulting and stained glass. A dog-leg is a configuration of stairs between two floors of a building, often a domestic building, in which a flight of stairs ascends to a quarter-landing before turning at a right angle and continuing upwards. [1]
The safest angle for a ladder is 75.5°; if it is too shallow, the bottom of the ladder is at risk of sliding, and if it is too steep, the ladder may fall backwards. This angle is achieved by following the 4 to 1 rule for a ladder placed on a vertical wall: for every four feet of vertical height, the ladder foot should move one foot from the wall.
The distance between the wall and handrail gripping surface is also governed by local code with the most common requirement being 1 + 1 ⁄ 2 inches (38 mm) minimum. The National Fire Protection Agency (NFPA) and the Occupational Safety and Health Administration (OSHA) require that the distance between the wall and handrail be a minimum of 2 ...
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
Ads
related to: attaching stair stringers to wall