enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical characteristics of dynamic loudspeakers - Wikipedia

   en.wikipedia.org/wiki/Electrical_characteristics...

   If a home hi-fi amplifier specifies 8 ohm or greater loads, care should be taken that loudspeakers with a lower impedance are not used, lest the amplifier be required to produce more current than it was designed to handle. Using a 4 ohm loudspeaker system on an amplifier specifying 8 ohms or greater could lead to amplifier failure.

3. Dynaquad - Wikipedia

   en.wikipedia.org/wiki/Dynaquad

   Updated Dynaquad speaker placement. A simpler form of Dynaquad was adopted, allowing an easy adaptation of existing home setups. The two forward speakers remain in their normal positions, with the user only needing to add two similarly positioned back speakers, forming a square (front-left, front-right, back-left, back-right).

4. Speaker wire - Wikipedia

   en.wikipedia.org/wiki/Speaker_wire

   [citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.

5. Linn Isobarik - Wikipedia

   en.wikipedia.org/wiki/Linn_Isobarik

   This 2-way, 4-ohm, design was a physically much smaller product – measuring 425 × 332 × 244 mm (16.7 × 13.1 × 9.6 in) – that required tall speaker stands. Launched in 1978, it was Linn's entry-level loudspeaker until the Kan (a non-isobaric bookshelf speaker using the same Linn D20-LP-1 and KEF B110 drive units as its big brother) was ...

6. Loudspeaker - Wikipedia

   en.wikipedia.org/wiki/Loudspeaker

   A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]

7. Line level - Wikipedia

   en.wikipedia.org/wiki/Line_level

   Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal voltages. The result will be very weak sound from the speaker and possibly a damaged line out circuit.