Search results
Results from the WOW.Com Content Network
Borg-Warner R-11 overdrive - 3-speed manual transmission with electric overdrive Ford used them up until 1975 in trucks. Borg-Warner T-50 transmission — 5-speed longitudinal manual - used by GM in its RWD H-Body cars and a few other limited light duty applications from 1976 to 1978;
The Muncie SM420 is a heavy duty, four-speed manual transmission that was produced from 1947 to 1967 by General Motors for civilian use in a variety of pickup trucks, buses, dump trucks and heavy equipment. They were used in some military vehicles into the 1980s. It was replaced in civilian vehicles by the Muncie SM465 transmission in 1968.
The new partnership sought with General Motors, resulted in the 50-50 General Motors Korea (GMK) joint venture. [20] Due to financial difficulties, Shinjin sold its stake of GMK in November 1976 to the Korea Development Bank (KBD), and GMK was retitled Saehan Motors. [1] [21] The KBD later sold this equity stake onto the Daewoo Group in 1978. [21]
A manual transmission requires the driver to operate the gear stick and clutch in order to change gears (unlike an automatic transmission or semi-automatic transmission, where one (typically the clutch) or both of these functions are automated).Shifting gears requires constant attention [1] Most manual transmissions for cars allow the driver to select any gear ratio at any time, for example ...
In 1891, the French Panhard et Levassor automobile used a three-speed manual transmission and is considered to have set the template for multi-speed manual transmissions in motor vehicles. [ 3 ] [ 4 ] This transmission used a sliding-gear design without any form of speed synchronization, causing frequent grinding of the gear teeth during gear ...
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [51] [52] [53] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges. For ...
Preselector gearboxes were most common prior to the widespread adoption of the automatic transmission, so they were considered in comparison to the "crash gearbox" type of manual transmission. Preselector gearboxes were often marketed as "self-changing" gearboxes, [ 1 ] however this is an inaccurate description as the driver is required to ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...