Search results
Results from the WOW.Com Content Network
For example, the wire speed of Fast Ethernet is 100 Mbit/s [1] also known as the peak bitrate, connection speed, useful bit rate, information rate, or digital bandwidth capacity. The wire speed is the data transfer rate that a telecommunications standard provides at a reference point between the physical layer and the data link layer. [2]
The distinction can be arbitrary between a computer bus, often closer in space, and larger telecommunications networks. Many device interfaces or protocols (e.g., SATA, USB, SAS , PCIe ) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure .
RJ45 is often incorrectly used when referring to an 8P8C connector used for ANSI/TIA-568 T568A and T568B and Ethernet, however, the plug used for RJ45 is both mechanically and electrically incompatible with any Ethernet port: it cannot fit into an Ethernet port, and it is wired in a way that is incompatible with Ethernet. The connector commonly ...
The distances that single pair operates at full duplex depends on the speed: 1000m (1km) with 802.3cg-2019 10BASE-T1L; 15 m or 49 ft with 100BASE-T1 (link segment type A); up to 40 m or 130 ft using 1000BASE-T1 link segment type B with up to four in-line connectors.
Cat 6 cable can be identified by the printing on the side of the cable sheath. [3] Cable types, connector types and cabling topologies are defined by ANSI/TIA-568.. Cat 6 patch cables are normally terminated in 8P8C modular connectors, using either T568A or T568B pin assignments; performance is comparable provided both ends of a cable are terminated identically.
Generally, layers are named by their specifications: [8] 10, 100, 1000, 10G, ... – the nominal, usable speed at the top of the physical layer (no suffix = megabit/s, G = gigabit/s), excluding line codes but including other physical layer overhead (preamble, SFD, IPG); some WAN PHYs (W) run at slightly reduced bitrates for compatibility reasons; encoded PHY sublayers usually run at higher ...
Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.
The most common type uses Category 5 cables (four twisted pairs with 100 ohm impedance) between 8P8C (colloquially and incorrectly called RJ45) room sockets and a central patch panel. The A and B wires of an analogue phone line appear in a structured cabling system usually on the centre pins of the 8P8C connector (pins 4 and 5; the blue/white ...