Search results
Results from the WOW.Com Content Network
A heat sink (also commonly spelled heatsink, [1]) is a passive heat exchanger that transfers the heat generated by an electronic or a mechanical device to a fluid medium, often air or a liquid coolant, where it is dissipated away from the device, thereby allowing regulation of the device's temperature.
Thermal Design Power (TDP), also known as thermal design point, is the maximum amount of heat that a computer component (like a CPU, GPU or system on a chip) can generate and that its cooling system is designed to dissipate during normal operation. Some sources state that the peak power rating for a microprocessor is usually 1.5 times the TDP ...
The SI unit of absolute thermal resistance is kelvins per watt (K/W) or the equivalent degrees Celsius per watt (°C/W) – the two are the same since the intervals are equal: ΔT = 1 K = 1 °C. The thermal resistance of materials is of great interest to electronic engineers because most electrical components generate heat and need to be cooled.
The most common design of a heat sink is a metal device with many fins. The high thermal conductivity of the metal combined with its large surface area result in the rapid transfer of thermal energy to the surrounding, cooler, air. This cools the heat sink and whatever it is in direct thermal contact with.
One-dimensional conduction; Uniform cross-sectional area; Uniform convection across the surface area; With these assumptions, conservation of energy can be used to create an energy balance for a differential cross section of the fin: [1] ˙ (+) = ˙ + ˙. Fourier’s law states that
In a cross-flow, in which one system, usually the heat sink, has the same nominal temperature at all points on the heat transfer surface, a similar relation between exchanged heat and LMTD holds, but with a correction factor. A correction factor is also required for other more complex geometries, such as a shell and tube exchanger with baffles.
The addition of a small heater on the reservoir, with the power controlled by the evaporator temperature, will allow thermal control of roughly ±1-2 °C. In one example, the evaporator temperature was maintained in a ±1.65 °C control band, as power was varied from 72 to 150 W, and heat sink temperature varied from +15 °C to -65 °C.
Typical LED package including thermal management design Thermal animation of a high powered A19 sized LED light bulb, created using high resolution computational fluid dynamics (CFD) analysis software, showing temperature contoured LED heat sink and flow trajectories Thermal animation of a high power density industrial PAR 64 LED downlight heat sink design, created using high resolution CFD ...