Search results
Results from the WOW.Com Content Network
A 2BA thread is used to connect the metal barrel of a dart to its shaft — as such, it is one of the few common uses of this thread in North America. In the UK, 2BA threads are commonly found in the old imperial British Engineering Standards Association (BESA) conduit boxes , and 4BA threads in light switch and socket back boxes which are ...
Dimensions of a square thread form. The square thread form is a common screw thread profile, used in high load applications such as leadscrews and jackscrews. It gets its name from the square cross-section of the thread. [1] It is the lowest friction and most efficient thread form, but it is difficult to fabricate.
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
British Standard Fine (BSF) is a screw thread form, as a fine-pitch alternative to British Standard Whitworth (BSW) thread. It was used for steel bolts and nuts on and in much of Britain's machinery, including cars, prior to adoption of Unified, and later Metric, standards.
On a screw, the bearing area loosely refers to the underside of the head. [1] Strictly speaking, the bearing area refers to the area of the screw head that directly bears on the part being fastened. [2] For a cylindrical bearing, it is the projected area perpendicular to the applied force. [3]
Rolling bearings; single row radial contact ball bearings: Active: DIN 625-3: Rolling bearings; double row radial contact ball bearings: Active: DIN 625-4: Rolling bearings; radial contact groove ball bearings with flanged outer ring: Active: DIN 653: Knurled thumb screws, low type: Active: DIN 678-1: Envelopes – Part 1: Sizes: Active: DIN 678-2