enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Micrometer adjustment nut - Wikipedia

   en.wikipedia.org/wiki/Micrometer_adjustment_nut

   The nut is located on a threaded rod on the mill head. The machine operator moves it up or down by rotating it clockwise (to move it down) or counter-clockwise (to move it up). Moving the nut down increases the depth to which the cutting tool may plunge into the workpiece. Moving the nut up reduces the depth to which the cutting tool may plunge ...

3. Differential screw - Wikipedia

   en.wikipedia.org/wiki/Differential_screw

   Many differential screw configurations are possible. The micrometer adjuster pictured uses a nut sleeve with different inner and outer thread pitches to connect a screw on the adjusting rod end with threads inside the main barrel; as the thimble rotates the nut sleeve, the rod and barrel move relative to each other based on the differential between the threads.

4. 4.3-10 connector - Wikipedia

   en.wikipedia.org/wiki/4.3-10_connector

   The 4.3-10 connector (sometimes referred to as 4.3/10) is a 50 Ω multi-purpose RF connector used to connect coaxial cables with other cables or RF devices, such as transmitters or antennas. The IEC standard 61169-54 specifies an inner diameter of the outer conductor is 10 mm and the outer diameter of the inner conductor is 4.3 mm.

5. Micrometer (device) - Wikipedia

   en.wikipedia.org/wiki/Micrometer_(device)

   Tube micrometers have a cylindrical anvil positioned perpendicularly to a spindle and is used to measure the thickness of tubes. Micrometer stops are micrometer heads that are mounted on the table of a manual milling machine, bedways of a lathe, or other machine tool, in place of simple stops. They help the operator to position the table or ...

6. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   The spindle can generally be lowered (or the table can be raised, giving the same relative effect of bringing the cutter closer or deeper into the work), allowing plunge cuts and drilling. The depth to which blades cut into the work can be controlled with a micrometer adjustment nut. There are two subcategories of vertical mills: the bed mill ...

7. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.

8. IEC metric screw sized connectors - Wikipedia

   en.wikipedia.org/wiki/IEC_metric_screw_sized...

   IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.

9. SMC connector - Wikipedia

   en.wikipedia.org/wiki/SMC_connector

   SMC jack connectors have an external thread while SMC plug connectors have the mating hex nut. The contact dimensions are identical to the snap-fit SMB. Available in 50 ohm and 75 ohm characteristic impedance, they provide an interconnect means for small form factor coaxial cables (e.g. 50 ohm RG-174 , 75 ohm RG-179 ) and printed circuit boards ...